Serial Connection - Sun Microsystems Netra t1 LOMlite Arbeiten

Power
The LOMlite device is powered by auxiliary power. It functions even when the rest
of the system is powered down.

Serial Connection

You access the LOMlite device by a terminal connected to the serial port as follows:
Connector:
Rate:
Parity:
Stop bits:
Data bits:
By default, this connection is shared with the console on the ttya port. You can
move the console to the ttyb port if required.
Controlling the LOMlite Device
You enter the LOMlite escape sequence to access the LOMlite console. The escape
sequence is #. (hash period) by default. To change the first character, enter the
following command:
# lomctl escape=X
X represents the required first character of the LOMlite escape sequence.
When you type the LOMlite escape sequence, the LOMlite device takes control of
the connection. The lom> prompt is displayed.
2 Using the Netra t1 LOMlite Device • October 1999
serial A/LOM
9600 baud
No
1
8