General Safety Check - Stiga Tornado 598e Gebrauchsanweisung

SAFETY INSTRUCTION
Always perform safety checks before use.

7.2.1 General safety check

Object
Battery
Rear discharge
protection, grass catcher
(only for models with
rear grass catcher)
Side discharge protection
(for models with side
discharge only)
Electrical cables
Status
Operator seated.
Drive pedal in neutral position
(pedal released).
Emergency button deactivated.
Machine on or in operation.
Operator seated.
Drive pedal in forward or
reverse position.
Emergency button activated.
Cutting means engaged.
Cutting means engaged.
Result
No damage to
casing and cover.
Good condition. No
damage. Properly
installed.
Good condition. No
damage. Properly
installed .
All insulation intact.
No mechanical damage.
Fully insert the key
The operator stands up from the seat. All services are deactivated. The
Try to start the machine.
Attempt to start the machine.
Reverse is activated without
holding down the reverse
mowing consent button.
Lift the grass catcher or remove
the rear discharge guard (for
rear collection models only)
Object
Operate the machine
forwards/reverse and
release the drive pedal.
Safety devices
7.2.2 Control of safety devices
The safety devices work in two ways:
A. they prevent the electric engine
from starting if all the safety
requirements have not been met;
B. by stopping the electric engine if even just
one of the safety requirements is lacking.
Action
EN - 21
Result
The machine slows
down and stops.
Proceed as indicated
in par. 7.2.2
Result
The machine is ready
to be turned ON.
icon in fig. 13.E icon flashes and
the icon in fig. 13.P is illuminated.
The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1, 2, 4 and 5 flash.
Pushbutton panel of type "I" e "II"
Pushbutton panel of type "III"
The machine switches ON. The
icon in fig. 7.E flashes and the
icon in fig. 7.O is illuminated. Drive
and cutting means do not work.
The cutting means disengage.
The cutting means disengage.