Stiga Tornado 598e Gebrauchsanweisung Seite 141

PROBLEM
12. The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1, 2, 3 and 5 flash.
Pushbutton panel type "I"
and "II"
Pushbutton panel of type
"III"
13. The battery LEDs in fig.
13.F turn ON and OFF
in sequence, from left to
right, and vice versa.
NOTE
For machines equipped with type "III" push-
button panel, together with the LED error
combination, a numeric error code is displayed
in the battery charge percentage digits (fig.
13.Y). If necessary, provide the numerical
error code to the Authorized Service Centre.
Cause
Drive engagement/
disengagement lever
in drive disengaged
position.
Communication error
between on-board
electronic modules.
EN - 35
Remedy
Check the position of the drive engagement/
disengagement lever and, if necessary,
return it to the drive engaged position.
If the problem persists, contact a Service Centre.
Switch off the machine and repeat
the starting procedure
If the problem persists, contact a Service Centre.
NOTE
For any further problems not listed
in the table, immediately contact an
Authorized Assistance Centre.