Beko HNU71311S Bedienungsanleitung Seite 13

5 Setting up the device
5.4 Drilling mounting holes
• Adhere the installation template provided with
the appliance onto the surface on which the in-
stallation will be carried out.
• Drill the holes indicated on the installation draft
with A, B, C, D, E, F using a Ø4 mm drill bit.
(Figure 1)
Figure 2
• Cut the lower surface of the cabinet where the
hood will be installed in the dimensions speci-
fied in the technical drawing (Figure 2).
Figure 3
1. 3.5x9.5 screw
2. Ø 120 mm plastic flue
3. BodyValve pin socket
• Attach the plastic flue contained in the pack-
age to the body of the appliance using 2 screws
3.5x9.5. (Figure 3) Do not rub it against the
surface.
Cooker Hood / User Manual
Figure 4
1. Air discharge pipe
2. Air exhaust flue of the hood
• Attach the air discharge pipe to the air exhaust
flue and fasten via clamp (Figure 4).
CAUTION: As the bends and elbows
A
in the aluminum pipe will cause de-
crease in the air suction power, us-
ing these must be avoided as much
as possible.
1
2
Figure 5
1. Kitchen cabinet bottom view
2. 6 x 3,9x32 hood installation screw
• Place the hood into the kitchen cabinet and at-
tach the hood to 6 installation holes drilled be-
fore (Figure 5).
5.5 Storage
• If you do not intend to use the appliance for a
long time, please store it carefully.
• Please make sure that the appliance is un-
plugged, cooled down and totally dry.
1
1
13 / EN