Electrical Connection; Contractors) - Bosch Tronic 5000 Installations- Und Bedienungsanleitung

Priority relay
Deactivated (Factory
settings)
Activated
Table 8 Setting the priority relay mode
6 Electrical connection (only for approved

contractors)

General information
DANGER
Risk of electric shocks!
▶ Disconnect the power supply before carrying out any work
on the device.
All regulation, control and safety equipment of the device is
connected at the factory and supplied ready for operation.
WARNING
Lightning strike!
▶ The device must have a separate connection in the
distribution box and be protected by a 30-mA fault current
circuit breaker and earth lead. A lightning protection device
must also be provided in areas characterised by frequent
lightning strikes.
6.1

Electrical connection

The electrical mains connection terminal can be assembled at
the top or at the bottom of the appliance.
The electrical connection can be made in 3 different ways,
• Upper connection (Fig. 40)
• Lower Connection (Fig. 41)
• Lower Connection with individual cables (Fig. 42)
▶ Carry out the electrical connections, according to the
position of the power cable.
The layout of the electrical cables must be in accordance
with the images below.
Tronic 5000 – 6721830067 (2021/06)
Jumper: J1
Electrical connection (only for approved contractors)
WARNING
Danger of electric shock!
The electrical connection of the appliance must satisfy the
following conditions:
▶ When using the upper or lower electrical connection, the
appliance may be installed in protection zone 1 or higher
(IP25) ( Fig. 8).
▶ When using the lower electrical connection with individual
cables, the appliance can only be installed outside of
protection zone 2 (IP23) ( Fig. 8).
Upper Connection
Fig. 40 Upper connection
Lower Connection
Fig. 41 Lower connection
23