Driving; Multifunction Display - Torqeedo Cruise 3.0 R Originalbetriebsanleitung

8.2.7 Driving

1. Switch on the Torqeedo system.
2. Set the tiller/accelerator lever to the neutral position.
3. Place the emergency stop magnetic chip or connect the kill switch line to
the switch, make sure the emergency stop magnetic chip or kills witch cord
is connected to the skipper.
4. Turn the tiller/accelerator lever in the appropriate direction.
NOTE! Take your Cruise motor out of the water if your Cruise motor is not driving
the boat (e.g. under sail) and your boat exceeds a speed of 10 knots through
water (STW).

8.2.8 Multifunction display

The tiller or accelerator lever is equipped with an internal or external display. It
shows all the important data about your trip.
You can adjust the units according to your needs, see chapter "Setting the battery
type and units of measurement" or the operating manual for the accelerator
lever.
NOTE! Depending on the configuration and the accelerator lever used,
the multifunction displays differ on the Cruise models without Tiller. The
corresponding information can be found in the operating manual for the
respective accelerator lever.
Multifunction display (only Cruise models with Tiller)
setup cal.
Normal operation
1
2
3
4
1 Battery charge state in percent
2 Remaining range at current speed
3 Speed over ground
4 Current power consumption in watts
Special displays
1
Drive slowly
2
Charging
3
Searching
4
Stop
5
6
ERROR
1 Drive slowly
2 Charging
3 GPS symbol
4 Stop position symbol
5 Overtemperature symbol
6 Error
DE EN
77