Maintenance And Repair; User Qualifications; Service Intervals; Cleaning - Torqeedo Cruise 3.0 R Originalbetriebsanleitung

Disconnecting the battery
NOTE! Observe the disconnection sequence when removing the battery for stor-
age or disconnecting the battery terminals.
1. Switch off the batteries.
2. Set the battery main switch to the off position.
3. Disconnect the black negative power cable from the negative terminal of
the battery.
4. Disconnect the red positive power cable from the positive terminal of the
battery.
5. Disconnect the bridge cables between the batteries when using more than
one battery.

10 Maintenance and repair

10.1 User qualifications

Repairs and maintenance not described in this operating manual may only be
carried out by qualified expert personnel from Torqeedo Service or a Torqeedo
service partner. Service must be carried out at the specified intervals or after the
specified operating hours by Torqeedo Service or by a Torqeedo service partner.
Failure to carry out or document the prescribed maintenance intervals will result
in loss of warranty and guarantee. Make sure that the maintenance carried out is
documented in your service booklet.

10.2 Service intervals

Service activities Check before each
use
Electronic Check stability;
accelerator lever check function
Replace O-rings and
shaft seals
Gear shaft
Batteries and battery
cables
Galvanic anode
Power cable plug
connection
Propeller Visual inspection

10.3 Cleaning

WARNING
Danger of injury from propeller! This can result in moderate or severe bodily
injuries.
• Observe the safety regulations.
• Watch out for people in the water.
• Always switch off the system via the battery main switch when working
on the propeller or other components.
DE
Check every six Service every 5
months or after 100 years or after 700
operating hours operating hours
(whichever comes
first)
Have replaced by
a certified service
partner
Visual inspection Have inspected by
a certified service
partner
Check cable for dam-
age; visual inspec-
tion; secure against
slipping and tipping
over; check tightness
of threaded cable
connection
Visual inspection;
change if necessary
Visual inspection
EN
81