Preparing The Saw For Operation; Assembling The Saw; Mounting The Guide Bar And Saw Chain - Stihl MSA 300.0 Gebrauchsanleitung

5 Preparing the Saw for Operation

4.11 Cleaning, Maintenance and
Repair
WARNING
■ The saw may start unintentionally if the battery
is left in place during cleaning, maintenance or
repair operations. This may result in serious
injury to people and damage to property.
► Remove the battery.
► Engage the chain brake.
■ Aggressive cleaning agents, a water jet or
pointed objects can damage the chainsaw,
guide bar, the saw chain and the battery. If the
saw, guide bar, saw chain or battery are not
cleaned correctly, components may no longer
function properly or safety devices may be
rendered inoperative. They may cause serious
injury to persons.
► Clean the saw, guide bar, saw chain and
battery as described in this instruction man‐
ual.
■ If the saw, guide bar, saw chain or battery are
not properly serviced or repaired, components
may no longer function properly or safety devi‐
ces may be rendered inoperative. This may
result in serous or fatal injury to people.
► Do not attempt to service or repair the
chainsaw or battery.
► If the chainsaw or the battery require servic‐
ing or repairs: Contact your STIHL servicing
dealer for assistance.
► Service or repair the guide bar and saw
chain as described in this User Manual.
■ The user may be cut by the sharp cutters
while cleaning or servicing the saw chain. This
may result in injury to the user.
► Wear work gloves made from resistant
material.
5 Preparing the Saw for
Operation
5.1 Preparing the Saw for Opera‐
tion
Perform the following steps before starting work:
► Make sure the following components are in a
safe condition:
– Chain saw, 4.6.1.
– Guide bar, 4.6.2.
– Saw chain, 4.6.3.
– Battery, 4.6.4.
0458-009-9801-A
► Check the battery,
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300,
500 chargers.
► Clean the saw,
15.1.
► Mount the bar and chain,
► Tension the saw chain,
► Fill up with chain oil,
► Check the chain brake,
► Check the controls,
► Check chain lubrication,
► If you cannot carry out this work: Do not use
your chainsaw and contact your STIHL servic‐
ing dealer for assistance.
6

Assembling the Saw

6.1 Mounting and Removing the
Bar and Chain
6.1.1 Mounting the Guide Bar and Saw
Chain
The guide bar and saw chain combinations that
can be used with the chain sprocket are listed in
the specifications,
► Turn off the chainsaw, engage the chain brake
and remove the battery.
2
1
► Rotate the nuts (1) counterclockwise until the
chain sprocket cover (2) can be removed.
► Remove the chain sprocket cover (2).
► Turn the tensioning screw (3) counterclock‐
wise until the tensioner slide (4) butts against
the left end of the housing.
► Fit the saw chain in the guide bar groove so
that the arrows on the tie straps on the top of
the bar point in the direction of rotation.
English
10.7.
6.1.1.
6.2.
6.3.
10.4.
10.5.
10.6.
20.1.
3
4
43