Mobile App And Wi-Fi Connection - cecotec CONGA 2090 Bedienungsanleitung

ENGLISH
Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned off during charging.
Wet & dry tank installation
Recommendation: It is not suggested to use the scrubbing function for the first-time use.
Open the tank's blue silicone lid, fill the tank with water and close it again.
Fig. 14
Install the tank in the robot following the indicated direction. Make sure the clip is properly
fastened.
Fig. 15
Attach the mop to the bottom part of the mop bracket with the Velcro.
Fig. 16
Manually press the clips on both sides of the Wet & dry tank and push it into its correct position.
You will hear a click when it is properly fixed. To remove it, press the Wet & dry tank release
button and pull from the Wet & dry tank.
Fig. 17
Note:
Do not use the scrubbing function while the robot is unattended.
Remove the Wet & dry tank when the robot is charging or not in use.
Add some cleaning agent if considered necessary.
Warning: Using cleaning agents in excess might block water outlets.
Recommendation: In order to achieve perfect scrubbing, it is suggested to moisten the mop
before using it.
5. OPERATION
Once the robot's light indicator changes from blinking orange to steady blue, the battery is fully
charged and the robot is ready to operate.
The robot cannot operate with low battery.
Remove all cables and obstacles from the floor before operating the robot in order to avoid
accidents and damage.
Robot buttons
Auto mode
30
From the standby mode, press the power button on the robot, the remote control or on the
App and the robot will automatically start operating. It will carry out a cleaning cycle in zigzag
motion and then another one in Edge mode. Once it has finished, it will return to the charging
base.
It is the most commonly used cleaning mode and it is used to clean the the whole house's
surface. The robot vacuums the floor's dust automatically, in and organized and efficient way,
as it features memory and gyroscopic navigation supported by its camera.
Moreover, it changes direction when it finds obstacles throughout its route and it returns to
the charging base in a smart and direct way once the cleaning is over. It includes Total Surface
function, through which the robot cleans the whole surface and, if necessary, returns to the
charging base to recharge its battery and finish cleaning.
Back home mode
The Back home mode can be activated at any point of any cleaning cycle.
Once it is activated, the robot will automatically return to the charging base.
Warning: Make sure not to charge the robot with the Wet & dry tank installed when it contains
water.

6. MOBILE APP AND WI-FI CONNECTION

In order to access all the robot's functions from wherever you are, it is suggested to download
the Conga 2000 App. You will be able to control the robot in the most efficient way, enjoying
the excellence of cleaning.
App advantages:
Control your robot in an easy and intuitive way.
Activate the cleaning process from any point.
Carry out settings and daily scheduling.
Choose between its different cleaning modes: Auto, Edge, Random, Twice, Scrubbing, Manual,
Back home, Spiral, Spot and Smart Area.
View how the robot creates an interactive map as it is cleaning.
Check the cleaned surface and the time taken.
Check the cleaning history.
Fig.18
Configuration:
Download the Conga 2000 App from App Store or Play Store.
1.
2. Create an account with your e-mail and a password.
Confirm login.
3.
Add your Conga robot.
4.
Connect to Wi-Fi.
5.
ENGLISH
31