Operation; Main Switch; Pressure Regulator And Product Injector; Pressure Regulator - Dibo ECN serie Bedienungsanleitung

E N
o p E R aT I o n

1 pressure regulator

2 chemical injection

operation

MAIN SWITCH

The switch has been carried out as a turn button switch. It has two positions:
• 0 = oFF
• 1 = on
If the machine has been carried out with a start/stopper system, the machine
will stop 30 seconds after releasing the gun. operate the spray gun and the
machine starts automatically.

PRESSURE REGULATOR AND PRODUCT INJECTOR

Pressure regulator:
1
The pressure regulator/regulating valve is mounted at the back side of
the cleaner in the neighbourhood of the pump. on the pressure regulator
is a turning button (not always present), where the spray pressure can be
established continuously.
The ECn-l has a pressure regulating valve present with a fixed factory
adjustment, which is not adjustable!
Turning the button to the right for a higher pressure (+).
Turning the button to left for a lower pressure (-).
The pressure can only be adjusted if the spray gun is operated.
The spray pressure is indicated on the pressure gauge.

Product injector (ECN-M):

2
The chemical injection is mounted at the back side of the machine in the
neighbourhood of the pressure regulator. The kind of injector can differ and/or
put on another place in the neighbourhood of the pressure regulator. By turning
the adjustable product injector to the right or the left, one can arrange the
supply of the product.
The other type of injector is directly integrated on the valve (fig 1) and can be
operated by a double spray lance. This one is not adjustable. Fill the product
tank only with permitted products.
Before taking the unit into use, first check if the used product is arranged to use
with the material of the unit.
at doubt get in touch with the salesman of the product or an acknowledged
DiBo technician.
1
DiBO 16
Fig. 1
2