Cleaning / Removing Of The Drain Pump Filter - Pkm WA6-ES1015D Bedienungsanleitung

7.2 Cleaning / Removing of the drain pump filter

❖ We strongly recommend to clean the drain pump filter regularly (monthly).
You have to clean the drain pump filter if the appliance does not drain the water
properly or does not run the spinning programme.
You have to clean the drain pump filter if the pump is blocked by any foreign
object (e.g. buttons, coins etc.).
WARNING! Do not clean the drain pump filter while the washing
machine is in operation! Switch off the appliance and disconnect it from
the mains before.
WARNING! If there is hot water in the washing machine, ensure before
residual water drainage that the water has cooled down completely. RISK
OF SCALDING! RISK OF BURNS!
1. Switch off the appliance and disconnect it from the mains.
2. Insert a flathead screwdriver or a key
panel carefully to open the cover. Flap it away towards the front. Remove the
cover. 39
3. Place a container in front of the opening.
4. Open the drain pump filter (C), but do not remove it completely. Rotate the drain
pump filter (C) in anti-clockwise direction until the water begins to run; s. fig.
below.
Key or flathead screwdriver are not included in the scope of delivery.
38
Depending on model.
39
38 into the small opening of the bottom cover
~ ~
119