Driving Instructions; Operation; Display; Error Codes - SoFlow SO1 Originalbetriebsanleitung

4. Driving instructions

4.1 Operation

First switch on your SO1 by pressing the start button for 2 seconds. You can turn off your SO1 again by pressing and holding the same button for a few seconds. If you press the start button only
briefly, you will turn off the front light, which is turned on by default. By pressing the button briefly and repeatedly, you switch the light back on.
Before starting your journey, make sure that the handlebars click into place.
First, switch on your SO1 by pressing and holding the power button for 2 seconds. You start your SO1 by using one leg to accelerate yourself and the device by pushing your foot off the ground
(like a conventional scooter). Now you can accelerate by pulling the throttle on the right side of the handlebar.
You can apply the rear brake by stepping on the rear fender. Make sure that you are standing in the middle of the mudguard so that the brake pad acts evenly on the rear wheel. The left brake
lever on the handle bar operates the electronic front brake. Shift your body weight to the rear to compensate for the braking effect of the brake. This allows safe and controlled braking. Always
be careful when using the front brake. It is advisable to apply the rear brake at the same time when using then front brake in order to brake evenly. By applying both brakes at the same time,
you will perform a full stop of the SO1.

4.2 Display

You will find the following information on the display:

Battery capacity

Speed


Error codes


Bluetooth

Light
4.3 Error codes
The control electronics of your SO1 continuously check the correct function of all important components. If your SO1 detects a malfunction, this is indicated on the display:
Error message:

E1: Communication failure

E2: Error with the brake

E3: Error with the transfer handles

E5: Error with the controller
Stop using SO1 immediately if the display shows one of these error messages. Switch the unit off and on again. Check the plug connection between the handlebars and the front bar that no dirt
will affect the contacts of the plugs. Make sure that the battery is fully charged. If the error message still persists, contact the SoFlow service at info@soflow.com.
copyright by www.soflow.com 13