Maintenance; Ipx4; Driving Instructions; Operation - SoFlow SO3 Originalbetriebsanleitung

The life and performance of a battery depends on its age, care and how often it has been used. Compared to other battery models, lithium ion batteries have very low self-discharge and a very
low memory effect, but they need to be charged periodically. Even if you do not use your scooter, the battery must be charged for at least 1 hour every 2 months, otherwise it will lose capacity.
Regular charging will prevent the battery from total discharge. Please note that an excessively discharged battery is irreparably damaged and must be replaced for a fee, hence the battery should
never be completely discharged during operation.
WARNING!

3.5 Maintenance

Do not try to charge the SO3 when the battery is already full. This could diminish the battery's capacity in the long run.
Before every ride, check all screws of the device, especially those of the handle and frontbar, the mudguard and the front and rear wheel. Tighten all screws firmly to ensure safety when using
your SO3.
Before each journey, check that the wheels are undamaged.
Check regularly that the brakes are correctly adjusted. You can adjust the braking force by adjusting the brake cable. If in doubt, contact your dealer.
Thoroughly clean the SO3 with a dry cloth after usage. The front and rear ball bearings must be lubricated from time to time. Ordinary bicycle oil can be used. Oil the area where the axle runs into
the wheel to ensure better durability.

3.6 IPX4

The SO3 is splash-proof according to IPX4 but not waterproof. You may therefore use the SO3 in light rain and drive through puddles on the ground. You must not immerse the SO3 in water or
expose it to heavy rain, otherwise the electronics may be damaged. Further information about the scope of protection according to IPX4 can be found on the Internet.
Definition IPX4
IP First digit for protection against solid particles
X Not specified

4. Driving instructions

4.1 Operation

First switch on your SO3 by pressing the start button for 2 seconds. You can turn off your SO3 again by pressing and holding the same button for a few seconds. If you press the start button only
briefly, you will turn off the front light, which is turned on by default. By pressing the button briefly and repeatedly, you switch the light back on.
Before starting your journey, make sure that the handlebars click into place.
First, switch on your SO3 by pressing and holding the power button for 2 seconds. You start your SO3 by using one leg to accelerate yourself and the device by pushing your foot off the ground
(like a conventional scooter). Now you can accelerate by pulling the throttle on the right side of the handlebar.
copyright by www.soflow.com
IP Digit 2 for protection againts liquids
4 Protected against splashing water from all directions
13