Maintenance; Ipx6; Driving Instructions; Operation - SoFlow SO4 Originalbetriebsanleitung

3.5 Maintenance

Do not try to charge the SO4 / SO4 PRO when the battery is already full. This could diminish the battery's capacity in the long run.
Before every ride, check all screws of the device, especially those of the handle and frontbar, the mudguard and the front and rear wheel. Tighten all screws firmly to ensure safety when
using your SO4 / SO4 PRO.
Before each journey, check that the wheels are undamaged.
Check regularly that the brakes are correctly adjusted. You can adjust the braking force by adjusting the brake cable. If in doubt, contact your dealer.
Thoroughly clean the SO4 / SO4 PRO with a dry cloth after usage. The front and rear ball bearings must be lubricated from time to time. Ordinary bicycle oil can be used. Oil the area
where the axle runs into the wheel to ensure better durability.

3.6 IPX6

The SO4 / SO4 PRO is splash-proof according to IPX6 but not waterproof. You may therefore use the SO4 / SO4 PRO in light rain and drive through puddles on the ground. You must not
immerse the SO4 / SO4 PRO in water or expose it to heavy rain, otherwise the electronics may be damaged. Further information about the scope of protection according to IPX6 can be
found on the Internet.
Definition IPX6
IP First digit for protection against solid particles
X Not specified

4. Driving instructions

4.1 Operation

First, switch on your SO4 / SO4 PRO by pressing and holding the start button for a few seconds. You can switch off your SO4 / SO4 PRO by pressing and holding the same button for a few
seconds. If you only press the light button for a few seconds, you will switch off the light that is on by default. By pressing it again, you switch the light back on
Before starting your journey, make sure that the handlebars click into place.
You start with the SO4 / SO4 PRO by using one leg to accelerate yourself and the device by pushing your foot off the ground (like a conventional scooter). Now you can accelerate by
pushing down the throttle lever on the right side of the handlebar.
You can operate the front disc brake by using the brake lever on the right side of the handlebars. By pulling the left brake lever you operate the rear disc brake. Shift your body weight
slightly to the rear to compensate for the braking effect of the brake. This allows safe and controlled braking. Always be careful when using the brake. Pull both brake levers to perform
a full stop of the SO4 / SO4 PRO.
copyright by www.soflow.com
IP Digit 2 for protection against liquids
Protection against strong water jets
6
13