Ipx4; Driving Instructions; Operation; Display - SoFlow SO1 PRO Originalbetriebsanleitung

Before every ride, check all screws of the device, especially those of the handle and frontbar, the mudguard and the front and rear wheel. Tighten all screws firmly to ensure safety when using
your SO1 PRO.
Before each journey, check that the wheels are undamaged.
Check regularly that the brakes are correctly adjusted. You can adjust the braking force by adjusting the brake cable. If in doubt, contact your dealer.
Thoroughly clean the SO1 PRO with a dry cloth after usage. The front and rear ball bearings must be lubricated from time to time. Ordinary bicycle oil can be used. Oil the area where the axle runs
into the wheel to ensure better durability.

3.6 IPX4

The SO1 PRO is splash-proof according to IPX4 but not waterproof. You may therefore use the SO1 PRO in light rain and drive through puddles on the ground. You must not immerse the SO1 PRO
in water or expose it to heavy rain, otherwise the electronics may be damaged. Further information about the scope of protection according to IPX4 can be found on the Internet.
Definition IPX4
IP First digit for protection against solid particles
X Not specified

4. Driving instructions

4.1 Operation

First switch on your SO1 PRO by pressing the start button for 2 seconds. You can turn off your SO1 PRO again by pressing and holding the same button for a few seconds. If you press the start
button only briefly, you will turn off the front light, which is turned on by default. By pressing the button briefly and repeatedly, you switch the light back on.
Before starting your journey, make sure that the handlebars click into place.
First, switch on your SO1 PRO by pressing and holding the power button for 2 seconds. You start your SO1 PRO by using one leg to accelerate yourself and the device by pushing your foot off the
ground (like a conventional scooter). Now you can accelerate by pulling the throttle on the right side of the handlebar.
You can operate the front disc brake and the electronic rear brake by using the brake lever on the left side of the handlebars. Shift your body weight slightly to the rear to compensate for the
braking effect of the brake. This allows safe and controlled braking. Always be careful when using the brake. Pull the brake lever firmly to stop SO1 PRO completely.

4.2 Display

You will find the following information on the display:
•
Light
•
Speed
•
Bluethooth
•
km absolut
copyright by www.soflow.com
IP Digit 2 for protection againts liquids
4 Protected against splashing water from all directions
14