V2 CU4 Bedienungsanleitung Seite 26

TRANSMITTERS OF THE RANGE
ADLER
Using a transmitter of the range ADLER it is possible changing the
functions of the control unit controlling the tubular motor.
ADVANCED PROGRAMMING
To perform ADVANCED programming it is necessary to remove
the cover plate of the remote control and carefully follow the
dedicated procedures for the various functions.
Each function can be selected by entering a code during the
programming procedure; following is a summary table of the
functions with their relative programming codes.
CODE FUNCTION
A B C
12 11 11 Storage of the transmitters
12 11 13 Deletion of all the stored transmitters
12 11 17 Storing of the level of intervention of the wind
sensor
12 11 18 Programming of the level of intervention of the
sun sensor
12 11 21 Programming of the level of temperature
A: Code to activate programming
B: Indicates channel 1 of the remote control; for channel 2 the
number is 12, for channel 3 the number is 13, etc. up to
channel 6
C: Code of the function to be programmed
The pictures that follow include references to the buttons and the
LEDs used during programming.
L1 L2 L3 L4
PROG
L5 L6
UP
STOP
DOWN
STORAGE OF THE TRANSMITTERS
ADLER
Transmitters may be memorised in two different ways:
1. By means of the MOT push-button
2. By means of the transmitter (PROG push-button)
m
WARNING: The first transmitter has to be memorized
following the procedure (storage by push-button MOT)
STORAGE BY MEANS OF THE
MOT PUSH-BUTTON
1. Power only the control unit to be programmed
2. Activate ADLER programming by holding down buttons 4 and
6 until the 6 LEDs turn on
3. Release the buttons and enter the code 12 11 11
The two highlighted digits indicate the remote control channel
to be recorded; for channel 1 the digits are 11, for channel
2 the digits are 12, for channel 3 the digits are 13, etc up to
channel 6. Once the codes have been entered, the LED of the
selected channel will blink for 2 minutes after which it exits
programming.
4. Press and then release the MOT key on the control unit: the
MOT1 LED lights up.
5. Press and hold down the PROG button of the TX1 remote
control until the motor starts to move in a direction
6. Release the PROG button: the motor will stop
7. Press the UP button of the motor raised the shade, or the
DOWN button if the motor lowered the shade.
8. Programming completed.
m
WARNING: The first transmitter memorised determines the
direction of movement of the motor. If the logic is altered, it is
necessary to delete all codes stored and repeat the previous steps
(see paragraph DELETING TRANSMITTERS).
STORAGE BY MEANS OF THE
PROG PUSH-BUTTON
To add other remote controls, proceed as follows:
1. Press and hold down the UP and DOWN buttons of a remote
control that is already recorded until the motor starts to move
in a direction
2. Release the buttons: the motor will stop
3. Press the UP or DOWN button on the new remote control
- 26 -