Installation; Unpacking And Positioning - Pkm IN 4-9 Bedienungsanleitung

Do not use a socket board or a multi socket when using 220–240 V/50
Hz alternate current (AC).All electrical connections which may be
damaged must be repaired by a qualified professional. All repairs should
be performed by your authorized after sales service.
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Check that the appliance and the power cord are not damaged.
4. Connect the appliance to a dedicated socket only.
5. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
6. Connect the appliance to the mains properly.
There must be a minimum distance of 100 mm between the hole and the wall

4. INSTALLATION

WARNING!

Unpacking and positioning

Installation / hob
1. Cutting the cupboard
or an adjacent cupboard.
31