Electrolux EB7L4CN Benutzerinformation Seite 29

CAUTION!
Carefully handle the glass,
especially around the edges
of the front panel. The glass
can break.
Step 1 Fully open the door.
Step 2 Lift and press the clamp‐
ing levers (A) on the two
door hinges.
Step 3 Close the oven door to the first opening position (approximately 70° an‐
gle). Hold the door at both sides and pull it away from the oven at an up‐
wards angle. Put the door with the outer side down on a soft cloth on a
stable surface.
Step 4 Hold the door trim (B) on
the top edge of the door at
the two sides and push in‐
wards to release the clip
seal.
Step 5 Pull the door trim to the
front to remove it.
Step 6 Hold the door glass pan‐
els on their top edge one
by one and pull them up
out of the guide.
Step 7 Clean the glass panel with
water and soap. Dry the
glass panel carefully. Do
not clean the glass panels
in the dishwasher.
Step 8 After cleaning, do the
above steps in the oppo‐
site sequence.
Step 9 Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise
the surface of the door may overheat.
11.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
A
2
B
ENGLISH 29
A
1