Using The Digital Timer; Resetting The Settings; Replacing The Batteries - Silvercrest Z31281 Montage-, Bedienungs- Und Sicherheitshinweise

Press the Digital timer / UNIT / Alarm / -
j
button to start the alarm function. The
4
Alarm symbol
18
j You can switch off the alarm function by
pressing the Digital timer / UNIT / Alarm / -
button again. The Alarm symbol
4
disappears from the display.
When the set alarm time is reached, an
j
audible alarm signal sounds for about one
minute.
j No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the Alarm symbol
flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.

Using the digital timer

Q
Press the MODE / + button
j
device enters the digital timer mode. This
comes after the alarm function.
Press the SET / WEIGHT MODE button
j
to enter the settings mode. The seconds
display value flashes.
You can use the MODE / + button
j
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
j
to store the set value and move on to setting
the minute display value. The minute display
value flashes.
You can use the MODE / + button
j
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
j
to store the set value and leave the settings
mode.
Press the Digital timer / UNIT / Alarm /
j
- button
to start the digital timer. The digital
4
timer indicator
21
Note: While the digital timer continues to
run, you can switch the device to another
function by pressing the MODE / + button
75609 CB5 content.indd 37
appears in the display.
18
18
until the
5
3
or the
5
to
4
3
or the
5
to
4
3
appears in the display.
5
The digital timer indicator
to appear in the display.
j You can switch off the digital timer by press-
ing the Digital timer / UNIT / Alarm /
- button again. The digital timer indicator
4
disappears from the display.
21
When the set time expires, an audible alarm
j
signal sounds for about one minute and the
previously set time appears on the display.
j No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the digital timer
indicator flashes in the display.
21
Note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.

Resetting the settings

Q
The reset button
j 11
back of the housing. Press this button to reset
all the settings to the default factory settings.

Replacing the batteries

Q
j When the batteries become weaker, the
battery charge state indicator
display will light up.
Replace the batteries as soon as the symbol
j
" " appears in the display. Weak or ex-
hausted batteries can affect the accuracy of
the measurement results.
Open the battery compartment
j
back of the scale.
j Remove the discharged batteries and dispose
of them properly in accordance with the ap-
plicable regulations (see section "Disposal").
j Insert two new batteries type CR2032,
3 V into the battery compartment
Make sure you fit the batteries the right way
round (polarity). The correct polarity is
shown under the battery compartment
Then close the battery compartment
j
.
Operation
then continues
21
can be found on the
in the
19
on the
8
.
8
.
8
.
8
GB/MT 37
7/5/2012 7:59:38 PM