Using The Digital Timer; Resetting The Settings; Replacing The Batteries - Silvercrest Z30170 Montage-, Bedienungsanleitung Und Sicherheitshinweise

Operation
j
When the set alarm time is reached, an
audible alarm signal sounds for about one
minute.
j
No audible alarm signal sounds if the set
time is reached when the device is
in the weighing mode. Instead the Alarm
symbol flashes in the display.
18
note:If no button is pressed within a peri-
od of two minutes, the kitchen scale's dis-
play automatically shows the time.
  U singthedigitaltimer
Q
j
Press the MODE/+ button
device enters the digital timer mode. This
comes after the alarm function.
j
The display shows the time of day.
j
Press the SET/WEIGHT MODE button
to enter the settings mode. The seconds dis-
play value flashes.
j
You can use the MODE/+ button
Digital timer/UNIT/Alarm/- button
set the value.
j
Press the SET/WEIGHT MODE button
to store the set value and move on to setting
the minute display value. The minute display
value flashes.
j
You can use the MODE/+ button
Digital timer/UNIT/Alarm/- button
set the value.
j
Press the SET/WEIGHT MODE button
to store the set value and leave the settings
mode.
j Press the Digitaltimer/UNIT/Alarm/-
button to start the digital timer. The digit-
4
al timer indicator
note:While the digital timer continues to
run, you can switch the device to another
function by pressing the MODE/+ button
. The digital timer indicator
5
tinues to appear in the display.
j
You can switch off the digital timer by press-
ing the Digitaltimer/UNIT/Alarm/- but-
ton again. The digital timer indicator
4
disappears from the display.
j
When the set time expires, an audible
10 GB/IE/CY
49402_Content_LB3.indd 10
until the
5
3
or the
5
to
4
3
or the
5
to
4
3
appears in the display.
21
then con-
21
21
alarm signal sounds for about one minute
and the previously set time appears on the
display.
j
No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the digital timer in-
dicator flashes in the display.
21
note:If no button is pressed within a peri-
od of two minutes, the kitchen scale's dis-
play automatically shows the time.
  r esettingthesettings
Q
j
The reset button can be found on the
11
back of the housing. Press this button to re-
set all the settings to the default factory set-
tings.
  r eplacingthebatteries
Q
j
When the batteries become weaker, the
battery charge state indicator
display will light up.
j
Replace the batteries as soon as the symbol
" " appears in the display. Weak or ex-
hausted batteries can affect the accuracy of
the measurement results.
j
Open the battery compartment
back of the scale.
j
Remove the discharged batteries and dis-
pose of them properly in accordance with
the applicable regulations (see section
"Disposal").
j
Insert two new batteries type CR2032,
3V into the battery compartment
Make sure you fit the batteries the right way
round (polarity). The correct polarity is
shown inside the battery compartment
j
Then close the battery compartment
in the
19
on the
8
.
8
.
8
.
8
10.05.10 17:54