Using The Digital Timer; Resetting The Settings; Replacing The Batteries - Silvercrest Z30170 Handbuch

Press the Digital timer / UNIT / Alarm / -
button to start the alarm function. The
4
Alarm symbol 18
You can switch off the alarm function by
pressing the Digital timer / UNIT / Alarm / -
button again. The Alarm symbol
4
disappears from the display.
When the set alarm time is reached, an
audible alarm signal sounds for about one
minute.
No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the Alarm symbol
flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.
©

Using the digital timer

Press the MODE / + button
device enters the digital timer mode. This
comes after the alarm function.
Press the SET / WEIGHT MODE button
to enter the settings mode. The seconds
display value flashes.
You can use the MODE / + button
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
to store the set value and move on to setting
the minute display value. The minute display
value flashes.
You can use the MODE / + button
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
to store the set value and leave the settings
mode.
Press the Digital timer / UNIT / Alarm /
- button to start the digital timer. The digital
4
timer indicator 21
Note: While the digital timer continues to
run, you can switch the device to another
function by pressing the MODE / + button
63925_silv_Digitale_Küchenwaage_content_LB5.indd 37
appears in the display.
18
18
until the
5
3
5 or the
to
4
3
5 or the
to
4
3
appears in the display.
.
5
The digital timer indicator
to appear in the display.
You can switch off the digital timer by press-
ing the Digital timer / UNIT / Alarm /
- button 4 again. The digital timer indicator
disappears from the display.
21
When the set time expires, an audible alarm
signal sounds for about one minute and the
previously set time appears on the display.
No audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the digital timer
indicator 21 flashes in the display.
Note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.
©

Resetting the settings

The reset button can be found on the
11
back of the housing. Press this button to reset
all the settings to the default factory settings.
©

Replacing the batteries

When the batteries become weaker, the
battery charge state indicator
display will light up.
Replace the batteries as soon as the symbol
" " appears in the display. Weak or ex-
hausted batteries can affect the accuracy of
the measurement results.
Open the battery compartment
back of the scale.
Remove the discharged batteries and dispose
of them properly in accordance with the ap-
plicable regulations (see section "Disposal").
Insert two new batteries type CR2032,
3 V into the battery compartment
Make sure you fit the batteries the right way
round (polarity). The correct polarity is
shown under the battery compartment
Then close the battery compartment
Operation
21 then continues
in the
19
8 on the
.
8
.
8
8 .
GB/MT 37
21.02.11 17:13