Using The Digital Timer; Resetting The Settings; Replacing The Batteries - Silvercrest 63925 Montage-, Bedienungsanleitung Und Sicherheitshinweise

j
P ress the Digital timer / UNIT / Alarm / -
button to start the alarm function. The
4
Alarm symbol appears in the display.
18
j
Y ou can switch off the alarm function by
pressing the Digital timer / UNIT / Alarm / -
button again. The Alarm symbol
4
disappears from the display.
j
W hen the set alarm time is reached, an
audible alarm signal sounds for about one
minute.
j
N o audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the Alarm symbol
flashes in the display.
note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.

Using the digital timer

Q
j P ress the MODE / + button
device enters the digital timer mode. This
comes after the alarm function.
j
P ress the SEt / WEIGHT MODE button
to enter the settings mode. The seconds
display value flashes.
j
Y ou can use the MODE / + button
Digital timer / UNIT / Alarm / - button
set the value.
j
P ress the SEt / WEIGHT MODE button
to store the set value and move on to setting
the minute display value. The minute display
value flashes.
j Y ou can use the MODE / + button
Digital timer / UNIT / Alarm / - button
set the value.
j
P ress the SEt / WEIGHT MODE button
to store the set value and leave the settings
mode.
j
P ress the Digital timer / UNIT / Alarm /
- button to start the digital timer. The digital
4
timer indicator appears in the display.
21
note: While the digital timer continues to
run, you can switch the device to another
function by pressing the MODE / + button
The digital timer indicator
to appear in the display.
j
Y ou can switch off the digital timer by press-
ing the Digital timer / UNIT / Alarm /
- button
18 21
j
W hen the set time expires, an audible alarm
signal sounds for about one minute and the
previously set time appears on the display.
j
N o audible alarm signal sounds if the set
time is reached when the device is in the
weighing mode. Instead the digital timer
indicator
18
note: If no button is pressed within a period
of two minutes, the kitchen scale's display
automatically shows the time.

Resetting the settings

Q
j
T he reset button
until the back of the housing. Press this button to reset
5
all the settings to the default factory settings.
3

Replacing the batteries

Q
j
or the W hen the batteries become weaker, the
5
to battery charge state indicator
4
display will light up.
j
R eplace the batteries as soon as the symbol
3
"
hausted batteries can affect the accuracy of
the measurement results.
j
or the O pen the battery compartment
5
to back of the scale.
4
j
R emove the discharged batteries and dispose
of them properly in accordance with the ap-
3
plicable regulations (see section "Disposal").
j
I nsert two new batteries type CR2032,
3 V
Make sure you fit the batteries the right way
round (polarity). The correct polarity is
shown under the battery compartment
j
T hen close the battery compartment
.
5
21
again. The digital timer indicator
4
disappears from the display.
flashes in the display.
21
can be found on the
11
" appears in the display. Weak or ex-
into the battery compartment
Operation
then continues
in the
19
on the
8
.
8
.
8
.
8
GB/MT 37