Promag 800 Compact Version, Remote Version; Checking The Battery Charge Level - Endress+Hauser Proline Promag 800 Index C Installationsanleitung

8

Promag 800 compact version, remote version

8.1 Replacing the battery
8.2 Preparatory information and steps
WARNING
L
Batteries may explode if not handled properly!
‣
Do not recharge batteries.
‣
Do not take batteries apart.
‣
Do not expose batteries to naked flame.
Replace the battery pack if a diagnostic message is output.
Observe the specified temperature range of the batteries.
8.2.1

Checking the battery charge level

1. Open System.
2. Open Power (battery).
3. Open State of charge battery 1 or State of charge battery 2.
4. Switch off the device as described below and replace the empty battery pack.
8.2.2 Shut down device
1. Open System.
2. Open Device management.
3. Open Device reset.
4. Select Shut down device.
5. Press OK to confirm.
 The device switches off and can be disconnected from the power supply without
data loss.
6. Replace the empty battery pack.
Endress+Hauser
EA01307D
13