Endress+Hauser Proline Promag 800 Index C Installationsanleitung Seite 11

2. Device powered by battery: set switch B to "ON" position (switch is located on the main
electronics module), see graphic below.
1 →
A B
3
T20
1.
‣
Close the cover.
7.5.2 Switching on the power of the transmitter housing, remote version
1. Device powered by mains power supply: connect the device to the mains.
Endress+Hauser
2 →
‣
Push the ribbon cable into the holder, plug in the plug, close the display
module.
2.
2.5 Nm
(1.8 lbf ft)
1.
EA01307D
2.
3.
11