Endress+Hauser Proline Promag 800 Index C Installationsanleitung Seite 8

EA01307D
4. Select switch off device.
5. Press OK to confirm.
 The device switches off and can be disconnected from the power supply without
data loss.
7.2.2 Switching off the power of the transmitter housing, compact version
1 →
T20
2.
‣
Loosen the Torx screws, open the
cover.
1. Devices powered by power unit: disconnect the device from the mains.
2. Device powered by battery: set switch B to "OFF" position (switch is located on the main
electronics module), see graphic below.
1
A B
8
2
1.
2.
‣
Open the display module, push the ribbon cable out of the holder,
disconnect the plug.
3.
1.
Endress+Hauser