Initial Operation Of The Device; Inserting/Replacing Batteries, Battery Icon; Activating And Setting The Date/Time - visomat comfort form Gebrauchsanweisung

C

4. Initial operation of the device

Insert the batteries provided into the device.
If the device is to be operated using mains power, the cable connector
of the mains adapter (not supplied) must be plugged into the socket
on the right-hand side of the device. The batteries are automatically
switched off.
Please only use the visomat mains adapter. See "Original spare parts
and accessories" on page 59.

5. Inserting/replacing batteries, battery icon

• Remove the battery compartment cover on the underside of the
device.
• Remove the old batteries from the device and insert the new ones.
Please ensure correct polarity (marking in battery compartment).
• Close the battery compartment by clipping the battery cover back
into the device.
When the "empty battery " symbol first appears in the display, you
are still able to take around 30 measurements. Please replace the bat-
teries within this time frame.

6. Activating and setting the date/time

The device has a date/time function that can be activated as required.
This function is deactivated on delivery.
When the date/time function is activated, the measurement results
are saved along with their date and time. This can make it easier to
view the readings at a later point.
EN-44
Operating the device Operating the device
Activating and deactivating the date/time function
Press the Start/Stop button to activate the date/time function. Then
immediately press one of the two Memory buttons while the full dis-
play is still visible. The function can be deactivated at any time using
the same procedure.
When the date/time function is activated, the device continues to dis-
play the time even when it is switched off. The power consumption for
this is extremely low.
Setting the date/time
Initially, the display will show the four-digit year
number (Figure 1). Press Memory button 1 to reduce
the year number or Memory button 2 to increase
the year number. Confirm the entry by pressing the
Start/Stop button.
You are now able to set the month. (Figure 2). Press
Memory button 1 to reduce the value or Memory but-
ton 2 to increase the value. Set the correct month
and confirm the entry by pressing the Start/Stop
button.
Repeat these steps to enter the day (Figure 2) and
the hours and the minutes (Figure 3).
After replacing the batteries, you will have to reset
the date and time.
Changing the date/time
To change the date and time, take the batteries out and wait until the
display goes off. Then you can reset the date and time.
C
Figure 1
Figure 2
Figure 3
EN-45