lamber S280 Handbuch Seite 22

Every evening, after MAINTENANCE o perations,
lift the overflow out of the tank, close the door and
push the switch "A" on the OFF position.
Push the button "R" until the lamp "H" is lighted.
After twenty minutes the lamp "H" is OFF.
Every 6 days add 1 kg of salt in tablets into the
bottle placed on the bottom of the tank.
Attention!: the regeneration starts only when
the machine is on the OFF position.
SALT CONTROL
Unscrew the plug of the salt container at the bottom of
the tank and put 1 kg coarse salt tablets in it.
Clean the gasket and screw the plug.
The lack of sault in the container causes damages for
the machine because of limestone, besides a
defective washing of glasses and dishes.
GLASSES POSITIONING
In order to obtain a successful dishwashing, it is
suitable to take care of the way dishes are
placed. It is suitable to place glasses, inside the
wire basket with the concave side towards the
bottom. Place mixed cutlery in a vertical position
into the suitable container minding not to cram
them and with hafts towards the bottom (see the
drawing).
CLEANSING AGENTS
Choice of the suitable cleansing agent is an
essential condition
extremely good washing results as regards
hygienic results. It is then important to consider
if you want to obtain
some points. First of all only highly alkaline and
chlorine-active
made for industrial dish-washing machines, must
be used and they must be produced by well-
known reliable Firms. Mean concentration of the
cleansing agents in powder must be 1,5÷2,5 g/lt.
Mean concentration of liquid cleansing agents
must be 2÷4 g/lt.
In order to avoid scales and corrosions, put the
cleansing agent above water level on the nearest
area of the sucking pump filter, in this way it will
immediately dilute and will not deposit on the
tank bottom.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and cups
you must add a surfactant on water (Brightener).
Your cleansing agent supplier will be able to
suggest the most suitable product. Your machine
is equipped with a rinse aid dispenser. Mean
concentration used is 0,15 g/lt.
DESCALING
When hard water is used you can find, inside the
machine and
sediments which must be removed both for
hygienic and operating reasons by a descaling
operation.
Operating process
intervention are suggested by your cleansing
agent supplier who has suitable products,
generally containing phosphoric acid.
In order to avoid damage to the machine do not
increase the quantities and once operations end
rinse abundantly.
SANIFICATION
At least each 30 days it would be useful to do
this operation which guarantees the complete
hygienic conditions of the machine. We suggest
to contact your cleansing agent supplier who will
give you quantity and name of the most suitable
product you can use and that, generally, is an
active chloride powder (100÷200 ppm).
In order to avoid damage to the machine do not
increase the quantities and, once operations end,
rinse abundantly.
22
antifoam products,
also on dishes, calcareous
and frequency
especially
of this