lamber S280 Handbuch Seite 21

First Section - FOR THE USER
WORKING AND USE
The glasswashing machine S280 can wash up to 900 mixed-size glasses every hour.
The machine protection degree is IP21, therefore it should not be washed with direct high pressure jet water.
The objects to be washed should be correctly arranged for a good washing-up result.
We suggest to descale glasses, from time to time, in order to remove calcareous and/or starchy sediments
by soaking them in suitable solutions suggested by your cleansing agent supplier.
If you need to buy new dishes remember the following: Dishes and cups: preference must be given to china or
non-porous pottery articles, with smooth surface. Glasses: choose a glass suitable to be washed in dish-
washing machines. Surfaces must be smooth and bottoms as flat as possible.
OPERATION BEFORE WORKING
B
EFORE STARTING THE WORKING OPERATION MA KE
:
SURE THAT
- the cock is open;
- the filter and
their housings;
- the wash arm and the rinse arm are free to
pivot;
- the rinse aid dispenser containers are loaded.
T :
HEN PROCEED
A
- Open the door and put into the tank,
possibly over the pump filter, about 30 gr.
of non-lathering detergent in powder.
Every 10 cycles add about 20 gr. of detergent.
If the machine is provided with an automatic
dosing device, control that the detergent is in its
container.
B
- Place the dishes in the basket minding to
previously remove all solid waste and fat.
Do not overload baskets, dishes must not be
placed one upon the other, water must have the
way to run on each part of the same.
C
- Turn the machine on by wall switch and
push the switch "A" on the ON position.
The green lamp "G" lights up and the machine
loads automatically (with closed Door). When the
level has been reached, the lamp "E" lights up .
D
- Put the basket into the machine.
Close the door and push the button "B".
the overflow are in
The green lamp "F" will light up and the cycle will
start for 2 minutes, including, besides the
washing, a five seconds stop and the rinsing of
fifteen seconds with clean water at 85°-90°C will
start. At the end of the cycle the lamp "F" will go
out.
Note: The rinse starts only when the temperature
of the water is 90°C.
Bear in mind that the opening of the door
interrupts the cycle and therefore the machine at
any moment. Pratically, the opening of the tank
works as an emergency device.
E
- Take the basket away and repeat the
operation "D".
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. Halos
might be caused by an insufficient rinsing: in this
case, check that the rinsing jets are clean and
there is a sufficient pressure in the water
distribution network.
In the case that residuals are present, check that:
• the washing jets are clean
• there is detergent
• the positions of the objects in the rack are
correct.
REGENERATING
(for machines with Water-softener)
If the glasswasher is equipped with a Water-
softener it is possible to Regenerate the water
(water cleaning).
ENGLISH