Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Service Data - ZANKER KOB65962XK Benutzerinformation

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation settle on
the food and in the cavity of the
oven.
There is no good cooking perform-
ance using the function: True Fan
Cooking PLUS.
There is no good cooking perform-
ance using the function: True Fan
Cooking PLUS.
The water in the cavity embossment
does not boil.
The water comes out of the cavity
embossment.
The display shows "12.00".

Service data

If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of the
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven for too
long.
You did not turn on the function:
True Fan Cooking PLUS.
You did not fill the cavity emboss-
ment with water.
The temperature is too low.
There is too much water in the cavi-
ty embossment.
There was a power cut.
oven cavity. Do not remove the rating plate from the
oven cavity.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings are cor-
rect.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
Refer to "Activating the function:
True Fan Cooking PLUS".
Refer to "Activating the function:
True Fan Cooking PLUS".
Set the temperature at least to 110
°C.
Refer to "Hints and tips" chapter.
Deactivate the oven and make sure
that the appliance is cold. Wipe the
water with a cloth or sponge. Add
the correct amount of water to the
cavity embossment. Refer to the
specific procedure.
Reset the clock.
23

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis