Clock Functions - ZANKER KOB65962XK Benutzerinformation

Warning! Make sure that the oven
is cold before you remove the
remaining water from the cavity
embossment.

Clock functions

Clock functions table
Clock function
TIME OF DAY
DURATION
END
TIME DELAY
MINUTE MINDER
Setting the time. Changing the time
You must set the time before you operate the oven.
The flashes when you connect the appliance to the
electrical supply, when there was a power cut or when
the timer is not set.
Press the or to set the correct time.
After approximately five seconds, the flashing stops and
the display shows the time of day you set.
To change the time of day press
until starts to flash.
Setting the DURATION
1. Set an oven function and temperature.
2. Press
again and again until
3. Press or to set the DURATION time.
The display shows
4. When the time ends,
signal sounds. The appliance deactivates
automatically.
5. Press any button to stop the acoustic signal.
6. Turn the knob for the oven functions and the knob
for the temperature to the off position.
8
To set, change or check the time of day.
To set how long the appliance operates.
To set when the appliance deactivates.
To combine DURATION and END function.
To set countdown time. This function has no effect on the operation of the
appliance. You can set the MINUTE MINDER at any time, also when the ap-
pliance is off.
again and again
starts to flash.
.
flashes and an acoustic
Application
Setting the END
1. Set an oven function and temperature.
2. Press again and again until
3. Press or to set the time.
The display shows .
4. When the time ends,
signal sounds. The appliance deactivates
automatically.
5. Press any button to stop the signal.
6. Turn the knob for the oven functions and the knob
for the temperature to the off position.
Setting the TIME DELAY
1. Set an oven function and temperature.
2. Press again and again until
3. Press or to set the time for DURATION.
4. Press .
5. Press
or to set the time for END.
6. Press to confirm.
Appliance turns on automatically later on, works for the
set DURATION time and stops at the set END time. At
the set time an acoustic signal sounds.
7. The appliance deactivates automatically. Press any
button to stop the signal.
starts to flash.
flashes and an acoustic
starts to flash.