Replacement Of Main Broom - Kranzle 1+1 Betriebsanleitung

First operation

Replacement of main broom

The broom roller bears 10 ea. rows of
alterned soft and hard bristles and
consists of two broom halves.
Width:
Dia.:
Dia, wear limit:
approx.
The broom roller is replaced as follows:
Remove three ea. Phillips screws,
turn broom roller 180°, remove
Phillips screws from second half. Pull
the drive pin out of the broom shaft.
To install, reverse above procedure.
480 mm (18.9")
250 mm (9.8")
180 mm (7.1")
Slue side broom up
Tilt machine back to rest on the
handlebar
21