Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX-CONTROLLED OPERATION
You can control the devices individually via your DMX-controller.
DMX-Mode
The device has two different DMX channel modes. The Control Board allows you, as described below, to
assign the DMX channel mode.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Press the MODE button until the display shows "Addr". Press ENTER to confirm.
Select the desired DMX Channel Mode 2CH/4CH and again press ENTER to confirm.
You can now set the desired address via the UP or DOWN buttons. Press ENTER once again to confirm.
Press the MODE button in order to return to the main menu.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain.
If several devices are addressed similarly, they will work synchronically.
Controlling:
After having addressed the LED SLS-6 UV Floor, you may now start operating it via your lighting controller.
DMX protocol
2 channel mode
Channel:
1
2
Strobe
4 channel mode
Channel:
1
2
Strobe
3
Programs via DMX
4
Speed via DMX
Value:
Function:
000 - 255
UV 0 ~ 100 %
000 - 009
No function
010 - 255
Strobe with increasing speed
Value:
Function:
000 - 255
UV 0 ~ 100 %
000 - 009
No function
010 - 255
Strobe with increasing speed
000 - 009
No function
010 - 199
Auto mode via DMX
200 - 255
Sound mode via DMX
000 - 255
Increasing speed in Auto /Sound modes via DMX
24/27
00095600, Version 1.0
Werbung
Inhaltsverzeichnis
