Operation; Stand-Alone Mode; Control Board - EuroLite LED SLS-6 UV Floor Bedienungsanleitung

OPERATION

After you connected the spot to the mains, the EUROLITE LED SLS-6 UV Floor starts running.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board and the
remote control or in DMX-controlled mode via any commercial DMX controller.

Stand-alone mode

In the stand-alone mode, the device can be used without controller.
Disconnect the device from the controller. Please refer to the instructions under chapter Control Board.

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
program or select a DMX channel mode.
MODE UP DOWN ENTER
Mode
Auto
Sound
Speed
Sensitivity
Silent scene
InFr
Addr
Slave
Color
Dimming
Enter the menu by pressing the MODE-button. Browse through the menu by
pressing UP or DOWN. Press ENTER in order to select the desired menu. You
can change the selection by pressing UP or DOWN. Press ENTER in order to
confirm. You can leave every mode by pressing MODE. The functions provided
are described in the following sections.
Program Description
Au-1
Auto programs (Master mode)
Program 1
Au-2
Program 2
Au-3 Program 3
So-1 Sound controlled mode (Master mode)
Program 1
So-2
Program 2
So-3 Program 3
Select the desired speed
SP 1—SP9
(increasing)
Microphone sensitivity
Se 1—Se9
Sound controlled mode (increasing)
Program continues automatically during periods
OFF
without music or bass-beat
Program does not automatically continue during
ON
periods without music or bass-beat
Control via IR remote
ON
:enable
Control via IR remote
OFF
:disenable
Setting DMX channel mode
2CH
DMX address setting
d 001~d 512 2 channels DMX mode
4CH
d 001~d 512 4 channels DMX mode
Slav Slave
Color presets (Master-Mode)
UV
0 ~ 255
0-100% for Auto mode, Sound mode and Color
dim 1 – dim9
presets
23/27 00095600, Version 1.0