Panasonic EY7442 Bedienungsanleitung Seite 9

-
CAUTION:
Set the clutch setting at this mark ( )
before actual operation.
n.
y
er
If the clutch handle cannot be set at
"drilling" or "hammering" mode after
drilling with clutch function, set the
clutch handle at position 1 and oper-
er
ate the clutch for a second.
Speed Selection
- Choose a low or high speed to suit
the use.
n.
-
The more the variable speed control
y
trigger is pulled, the higher the speed
becomes.
er
WARNING:
• Do not inhale any smoke emitted
from the tool or battery pack as it
may be harmful.
CAUTION:
• Check the speed selector switch
before use.
• Use at low speed when high torque
is needed during operation. (Using
at high speed when high torque is
required may cause a motor
breakdown.)
• Do not use the tool in a manner
that causes the motor to lock up.
Doing so may damage the tool and
g
battery pack, resulting in smoke or
fire.
• Do not operate the speed selector
switch (LOW-HIGH) while pulling
on the speed control trigger. This
can cause the rechargeable battery
to wear quickly or damage the in-
ternal mechanism of the motor.
* See specifications for "MAXIMUM
RECOMMENDED CAPACITIES".
EY7442_7450_7950(EU).indb
HIGH
LOW
9
CAUTION:
• To prevent excessive temperature in-
crease of the tool surface, do not op-
erate the tool continuously using two
or more battery packs. The tool needs
cool-off time before switching to an-
other pack.
• Do not close up vent holes on the
sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
• Do NOT strain the tool (motor). This
may cause damage to the unit.
• Use the tool in such a way as to pre-
vent the air from the body vent holes
from blowing directly onto your skin.
Otherwise, you may get burned.
Bit-locking Function
1. With the trigger switch not engaged
and a screwdriver bit locked in
place, the tool can be used as a
manual screwdriver.
(EY7442: up to 36 N·m, 367kgf-cm, 319 in-lbs)
(EY7450, 7950: up to 40 N·m, 408kgf-cm,
353 in-lbs)
There will be a little play in the
chuck, but this is not a malfunction.
2. This feature is handy for tightening
screws that require more torque
than the maximum torque of the
driver (position
confirming the tightness of a screw
or to loosen an extremely tight
screw.
Control Panel
(1)
-  -
on the clutch), for
(3)
(2)
2011-3-1 11:33:57