Panasonic EY7442 Bedienungsanleitung Seite 12

Li-ion Battery Pack
NOTE:
Your battery pack is not fully
charged at the time of purchase.
Be sure to charge the battery be-
fore use.
Battery charger
1. Plug the charger into the AC outlet.
2. Insert the battery pack firmly into the
charger.
1. Line up the alignment marks and
place the battery onto the dock on
the charger.
2. Slide forward in the direction of the
arrow.
3. During charging, the charging lamp
will be lit.
When charging is completed, an in-
ternal electronic switch will auto-
matically be triggered to prevent
overcharging.
• Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
The orange standby lamp will be
flashing until the battery cools down.
Charging will then begin automati-
cally.
EY7442_7450_7950(EU).indb 12
4. The charge lamp (green) will flash
5. When charging is completed, the
6. If the temperature of the battery pack
7. Consult an authorized dealer if the
Alignment marks
8. If a fully charged battery pack is in-
9. Remove the battery pack while the
-  -
slowly once the battery is approxi-
mately 80% charged.
charging lamp in green color will turn
off.
is 0°C or less, charging takes longer
to fully charge the battery pack than
the standard charging time.
Even when the battery is fully charged,
it will have approximately 50% of the
power of a fully charged battery at
normal operating temperature.
charging lamp (green) does not turn
off.
serted into the charger again, the
charging lamp lights up. After several
minutes, the charging lamp in green
color will turn off.
battery pack release button is held up.
Battery pack
release button
L
In
Eq
2011-3-1 11:33:58