Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
Pump draining (on some models)
•
W ater can be automatically emptied into a floor drain or a suitable drainage facility
by attaching the pump drain outlet with a pump drain hose(Φod=1/4", supplied).
•
I nstall the pump hose into the pump hose intake of the unit, and rotate it.
•
I nstall the pump drain hose into the pump drain hose outlet for depth of 15mm at
least, then lead the water hose to the floor drain or a suitable drainage facility.
•
P ut the dehumidifier on the bucket again.
•
P ress and hold on the Up/Down buttons for 2 second to initiate PUMP feature.
When the PUMP is activated, the bucket capacity is at the 4th fill level and cannot
be selected. The PUMP works only if the bucket is full of water at the 4th fill level.
G
NOTE
The pump may cause big noise when it starts to work for 3~5 minutes. It is a
normal phenomenon.
•
M ake sure the hose is secure so there are no leaks.
•
D irect the hose toward the drain, making sure that there are no kinks that will stop
the water flowing.
•
P lace the end of the hose into the drain and make sure the end of the hose is level
or down to let the water flow smoothly. Do never let it up.
•
S elect the desired humidity setting and fan speed on the unit for pump draining to
start.
Note: The pump operation on light blinks at 1Hz when the pump is operational failure.
Please turn off the unit and plug the power cord out. Check the following things:
4
85
Werbung
Inhaltsverzeichnis
