Qlima D 720 Cube Gebrauchsanweisung Seite 67

control device.
• T he appliance shall be installed in accordance
with national wiring regulations.
• C ontact the authorised service technician for
repair or maintenance of this unit.
• T urn off the product when not in use.
• T he manufactures nameplate is located on the
rear panel of the unit and contains electrical
and other technical data specific to this unit.
• B e sure the unit is properly grounded. To
minimize shock and fire hazards, proper
grounding is important. The power cord is
equipped with a three-prong grounding plug
for protection against shock hazards.
• Y our unit must be used in a properly grounded
wall receptacle. If the wall receptacle you intend
to use is not adequately grounded or protected
by a time delay fuse or circuit breaker(please
refer to the nameplate for the electrical data),
have a qualified electrician install the proper
receptacle.
• D o not operate your appliance in a wet room
such as a bathroom or laundry room.
• T he unit s circuit board(PCB) is designed with a
fuse to provide overcurrent protection.
• T he specifications of the fuse are printed on the
circuit board, such as: T 3.15A/250V (or 350V),
etc.
Note about Fluorinated Gasses (Not applicable to
the unit using R290 Refrigerant)
1. F luorinated greenhouse gases are contained
in hermetically sealed equipment. For specific
information on the type, the amount and the
CO2 equivalent in tonnes of the fluorinated
greenhouse gas(on some models), please refer
to the relevant label on the unit itself.
4
67 67