Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FILL LEVEL button
•
Control the bucket capacity.Press to select bucket capacity in four steps-1, 2, 3 and 4.
When turn on pump function, the pump indicator light illuminates and the bucket
capacity will be at 4 step.
Timer button
•
Press to initiate the Auto start or Auto stop feature, in conjuction with the ▲ and
▼ buttons. When the unit is on, press the Timer button to activate the Auto stop
feature. When the unit is off, press this button to activate the Auto start feature.
•
Press or hold the ▲ and ▼ button to change the Auto time by 0.5 hour increments,
up to 10 hours, then at 1 hour increments up to 24 hours.
•
The control will count down the time remaining until start.
•
The selected time will register in 5 seconds and the system will automatically revert
back to display the previous humidity setting.
•
Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will
cancel the Auto start or Auto stop feature.
•
When LED display window displays the code of P2, the Auto start or Auto stop feature
will also be cancelled.
PUMP feature(On some models)
•
Press and hold on the Up/Down buttons 2 second to initiate PUMP feature.Press and
hold on the Up/Down buttons 2 seconds again to stop PUMP feature. Turn on the
PUMP feature, the bucket capacity cannot be selected and the bucket capacity is at 4
step.
G
NOTE
When the PUMP feature is actived, it works when the water is full at 4 step.
FRESH feature(On some models)
•
Press and hold on the Up/Down buttons 2 seconds to initiate FRESH feature, and the
fresh indicator light illuminates(The fresh indicator light and the UV indicator light
illuminate at the same time on some models; Only the UV indicator light illuminate
on some models ).The ion generatoris energized and will help to purify the air inside.
Press and hold on the Up/Down buttons 2 seconds again to stop FRESH feature, and
the fresh indicator light turns dark.
Wireless button(On some models)
•
Press and hold on the POWER button for 3 seconds to initiate the Wireless connection
mode. The LED DISPLAY shows'AP' to indicate you can set Wireless connection.
If connection (router) is successful within 8 minutes, the unit will exit Wireless
connection mode automatically and the Wireless indicator illuminates and the unit
enters the previous function. If connection is failure within 8 minutes, the unit exits
the Wireless connection mode automatically.
Display
•
Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while
setting, then shows the actual(±5% accuracy) room % humidity level in a range of 30%
RH(Relative Humidity) to 90% RH(Relative Humidity).
4
79
Werbung
Inhaltsverzeichnis
