Getting Started - Therabody RecoveryAir Prime Schnellstartanleitung

Getting started

1. To turn on the RecoveryAir Prime pump, press and hold the power button.
2. To get started, put your boots on first before attaching them to the pump. This allows you to
get into the most comfortable position and avoid any disruption in the air flow connection.
EN
3. Next, plug in the connector from the boots into the pump. Make sure you hear a "click" so that
you know the RecoveryAir Prime is fully connected, is plugged in, and there is a proper seal.
4. Once connected and comfortable, you are ready to customize your treatment.
Prepare your treatment
1. To turn on the RecoveryAir Prime pump, press and hold the power button.
2. Access two preset program options when connected to the Therabody app: Recover and
Warm-up.
3. Once you have chosen your desired program, use the (<) and (>) buttons to adjust the pressure
setting.
4. Then, toggle through the time options using the Time button to set your desired treatment time
(20min, 40min, 60min, or continuous).
5. Once you have selected the treatment options that are right for you, press start, relax, and you'll be
on your way to recovery in no time.
3