Graphical Symbols On The Device; General Notes On Safety - Parkside PWD 25 A2 Originalbetriebsanleitung

GB IE
Precaution symbol with in-
formation on prevention of
harm / damage
Notice symbol with informa-
tion on how to handle the
device properly
Graphical symbols on the
device
Protection class II
(Double insulation)
Read the instruction manual
Button for filter cleaning sys-
tem
Electrical devices must not
be disposed of with domes-
tic waste
For cold ash only*!
C
There is a risk of fire if the
suction material exceeds
a temperature of 40 °C
(104 °F)!
* "Cold ash" is ash that has
cooled down for a sufficient
amount of time and no longer
contains any embers. This can
be determined by combing the
ashes with a metal tool before
using the device. There will no
longer be noticeable heat radi-
ating from the cold ash.

General notes on safety

Caution! When using electri-
cal machines, observe the
following basic safety meas-
20
ures for the prevention of
electric shocks and the risk
of injury and fire:
To avoid accidents and injuries:
• Never leave a machine which
is ready for operation unat-
tended at the workplace.
• People and animals must not
be vacuumed with the ma-
chine.
• Do not aim the suction hose
and nozzle at yourself or oth-
ers during use, particularly not
at the eyes and ears; there is a
risk of injury.
• Do not vacuum any hot, incan-
descent, flammable, explosive
materials, or those which en-
danger health. This includes
hot ashes, petrol, solvents,
acids or caustic solutions. Per-
sonal injury could occur.
• Nozzles and suction tubes must
not reach head level whilst in
use. Personal injury could oc-
cur.
To avoid accidents and injuries
from electric shocks:
• Ensure that the mains cable is
not damaged by being pulled
over sharp edges, by jamming,
or by pulling on the cable.
• Before each use, check the
power supply lead and the ex-
tension cable for damage and
ageing. Do not use the equip-
ment if the cable is damaged
or worn. Danger of electric
shock hazard.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-