Gas Requirements; Connection To A Gas Bottle - Blumfeldt Heatwave Bedienungsanleitung

Step 5
Attach the wheels to the bottom of the unit base with 2 screws (M6x12) and
washers (ignore this step if the wheel set is already pre-installed).

GAS REQUIREMENTS

• A standard gas pressure regulator according to EN16129 and a standard
gas hose according to EN16436-1 with a length of at least 0.5 metres must
be used for the unit.
• Never use a gas cylinder with a damaged housing, valve, sleeve or foot ring.
A damaged or rusted gas cylinder can be dangerous and should be checked
by a gas cylinder dealer.
• Never connect this appliance to an unregulated gas source.
• Turn off the gas bottle when the appliance is not in use.
• When connecting a gas cylinder, always carry out a leak test on all
connections. If bubbles form during the leak test, do not use the appliance
under any circumstances. Never test for leaks with an open flame.

CONNECTION TO A GAS BOTTLE

• Follow the operating instructions for the gas bottle.
• Only change gas cylinders outdoors or in well-ventilated areas at a safe
distance from ignition sources.
• The gas bottle must be in an upright position at all times.
• Turn the control knob of the heater to the "OFF" position by turning it fully
clockwise.
• Close the gas bottle valve and attach the gas pressure regulator to the gas
bottle.
• Tighten all connections firmly, using an open-ended spanner if necessary.
The gas bottle should be on the gas bottle base.
• Check all connections for leaks with a soap solution. If there is a leak,
tighten the connector where the leak occurred and perform the test again.
• When installing the gas cylinder in the device housing, it must be fastened
with the straps located in the device housing.
EN
25