Cabling The Connection Terminal - Cameo H1 FC Bedienungsanleitung

CABLING THE CONNECTION TERMINAL

HAZARD: Opening the spotlight and connecting cables to the terminal connector
requires specialist knowledge and may only be carried out by specially trained person-
nel! If you are not suitably qualified, do not attempt to open the spotlight and attach the
cable yourself. Refer instead to a qualified professional.
The manufacturer shall not be liable for any damage to property or personal injury
caused by improper handling.
Before wiring the spotlight, make sure that the power cable intended for connection is
not live!
DMX cables must not be used to suspend the spotlight from a ceiling or similar. DMX
cables may only be used for signal supply.
Loosen the 4 screws (A) on the terminal cover with a suitable tool and remove the cover from the
spotlight housing.
The terminal cover has 3 cable bushings. Feed a suitable 3-core mains cable (zero potential!)
through the larger cable bushing (B) and 1 (only DMX IN) or 2 DMX cables (DMX IN and OUT)
through the smaller cable bushing(s) (C).
A
SAFETY
CABLE
DMX IN
C
B
A
A
DMX OUT
C
POWER IN
AC 100-240 V
50 / 60Hz
A
15