Cameo H1 FC Bedienungsanleitung Seite 22

SYSTEM SETTINGS (Settings)
Select Settings and confirm.
This will take you to the submenu for configuring the submenu items (see table):
Settings
DMX Fail = Operational
Dimmer = Dimmer
Curve
Dimmer = Dimmer
Response
PWM Fre- = Configura-
quency
Calibration = Colour cali-
22
Hold
status with
Fade Out
DMX signal
Blackout
fault
Full On
User Colour 1
Linear
curve
Exponential
Logarithmic
S-curve
LED
response
Halogen
800 Hz / 1200 Hz /
tion of PWM 2000 Hz / 3600 Hz /
frequency 12 kHz / 25 kHz
Type Factory Cali-
bration bration
User Calibra-
tion
RAW
Last command is retained
10 seconds Fade Out
Activates blackout
All LEDs 100% output
User Colour 1
Light intensity increases linearly
with DMX value
Light intensity can be finely adjusted
at lower DMX values and broadly
adjusted at higher DMX values
Light intensity can be broadly
adjusted at lower DMX values and
finely adjusted at higher DMX values
Light intensity can be finely adjusted
at lower and higher DMX values and
broadly adjusted at medium DMX
values.
Light responds abruptly to changes
in DMX value
Light behaves like a halogen spot-
light with slight brightness changes
Factory calibration of R, G, B, A and L
(across all modes)
Individual color calibration. Cross-
mode brightness setting of R, G, B, A
and L with values from 000 - 255.
R, G, B, A and L with maximum value
255