Cameo H1 FC Bedienungsanleitung Seite 26

For suspended installation, the mounting bracket can be completely removed from the spotlight to
create a consistent and discreet appearance.
To do this, loosen and both knob screws (A) from the mounting bracket and remove it. Remove the
sockets (B) on each side of the spotlight with a suitable tool. Cover the mounting holes (C) with
the sliding metal strips in the grooves (D). Keep all removed components safe for later use.
A
1. Only the securing lug and a suitable security cable should be used to suspend the spotlight. In
this case, mount the terminal cover so that the securing lug is located in the center of the spot-
light connection panel (E).
2. Thanks to its low weight, the spotlight can also be suspended from the ceiling or similar using
a suitable power cable (recommended: H07RN-F 3G1.5). In this case, mount the terminal cover so
that the cable bushing for the power cable is located in the center of the spotlight connection pan-
el (F). The load must be completely on the power cable and must not be distributed over additional
connected cables! In order to prevent the spotlight from falling, a suitable strain relief must be
provided for the power cable on both the spotlight and the suspension point side!
1
E
26
B
Similar to image
2
FUSE T2A / 250 V
DMX IN / OUT
C
SAFETY
CABLE
DMX IN DMX OUT
F
POWER IN
AC 100-240 V
50 / 60Hz
FUSE T2A / 250 V
DMX IN / OUT
D