Care And Maintenance - Cleaning Lenses; Optional Accessories; Dmx Technology; Dmx Connection - Cameo F1 FC Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

CARE AND MAINTENANCE – CLEANING LENSES

The front lens (E) and its rubber frame can be cleaned by flipping the retaining

bracket upwards as previously described and then drawing the front lens and its

rubber frame as well as the filter frame upwards out of the retention arms. Clean

the front lens with a moist, lint-free cloth, making sure not to scratch the surface of

the lens. Do not put the front lens and filter frame back into the support arms until

all equipment and accessories are completely dry. Then return the retaining bracket

back to its downward position until the lock pins click into place.

A mounting plate with V-mount adapter and connection cable for an external standard 14.4 or 14.8 volt V-mount battery is optionally

available.

Article number: CLF1VMOUNTAP

DMX-512

DMX (Digital Multiplex) is the designation for a universal transmission protocol for

communications between corresponding devices and controllers. A DMX controller sends

DMX data to the connected DMX device(s). The DMX data is always transmitted as a serial

data stream that is forwarded from one connected device to the next via the "DMX IN" and

"DMX OUT" connectors (XLR plug-type connectors) that are found on every DMX-capable

device, provided the maximum number of devices does not exceed 32 units. The last device

in the chain needs to be equipped with a terminator (terminating resistor).

DMX is the common "language" via which a very wide range of types and models of equipment from various manufacturers can

be connected with one another and controlled via a central controller, provided that all of the devices and the controller are DMX

compatible. For optimum data transmission, it is necessary to keep the connecting cables between the individual devices as short as

possible. The order in which the devices are integrated in the DMX network has no influence on the addresses. Thus the device with

the DMX address 1 can be located at any position in the (serial) DMX chain: at the beginning, at the end or somewhere in the middle.

If the DMX address 1 is assigned to a device, the controller "knows" that it should send all data allocated to address 1 to this device

regardless of its position in the DMX network.

Inhaltsverzeichnis

Clf1fc