Storage; Disposal; After-Sales/Service - AL-KO SUB 6500 Betriebsanleitung

GB
NOTE In the event of faults that you cannot
rectify, please contact our Customer Service de-
partment.
Malfunction Possible
cause
Engine does Impeller
not start. blocked.
Thermal pro-
tection switch
has switched
off.
No mains
power.
Float switch
does not trip
when the wa-
ter level rises.
16
Remedy
Remove dirt
from the suction
area. Clean with
a suitable tool
through the
opening on the
back of the mo-
tor housing.
Wait until the
thermal protec-
tion switches on
the pump again.
Take note of the
maximum tem-
perature of the
conveying medi-
um. Have the
pump inspected.
Check the fus-
es, have the
power supply
checked by a
qualified electri-
cian.
Send the pump
to an AL-KO
service facility.
Malfunction Possible
cause
Pump run- Air in pump
ning but housing.
does not
feed.
Blockage on
the suction
side.
Pressure line
closed off.
Pressure
hose kinked.
Delivery rate Hose diame-
too low ter too small.
Blockage on
the suction
side.
Feed head
too high.

10 STORAGE

NOTE If there is the danger of frost, the sys-
tem must be completely drained and the pump
must be stored in a frost-proof place.

11 DISPOSAL

Electrical and electronic appliances do not
belong in household waste, but should be
collected and disposed of separately.
Packaging, equipment and accessories are made
from recyclable materials, and must be disposed
of accordingly.

12 AFTER-SALES/SERVICE

In the event of questions of warranty, repair or
spare parts, please contact your nearest AL-
KO Service Centre. These can be found on the
Internet at:
www.al-ko.com/service-contacts
SUB 6500/8500 - DRAIN 7000/7200/7500/9500
Storage
Remedy
Vent the pump
by holding it at
an angle.
Remove dirt
from the suction
area.
Open the pres-
sure line.
Straighten the
pressure hose.
Use a hose with
a bigger diame-
ter.
Remove dirt
from the suction
area.
Observe the
max. feed head,
see technical
data!