Maintenance And Care; Flushing The Pump; Remove Blockages; Storage - AL-KO GP 600 ECO Betriebsanleitung

GB

7 MAINTENANCE AND CARE

7.1

Flushing the pump

After conveying swimming pool water containing
chlorine or fluids that leave residues, the pump
must be flushed out with clear water.
7.2

Remove blockages

1. Disconnect the pump from the mains supply
and secure to prevent restarting.
2. Disconnect suction line from pump inlet.
3. Connect pressure line to the water line.
4. Allow water to run through the pump housing
until the blockage is removed.
5. Switch on the pump briefly to check whether
it runs smoothly.
6. Put the pump into operation as described.

8 STORAGE

1. Drain suction and pressure line.
2. Unscrew drain plug and allow the water to
drain out of the pump.
3. Screw in the drain plug again and store pump
and accessories in a frost-proof place.
NOTE
If there is the danger of frost, the system
must be completely drained and the
pump must be stored in a frost-proof
place.

9 DISPOSAL

Electrical and electronic appliances do not
belong in household waste, but should be
collected and disposed of separately.
The packaging, device and accessories are
made of recyclable materials, and must be dis-
posed of accordingly.
22
Maintenance and care
GP 600 ECO | GPI 600 ECO