Storage; Disposal; Help In Case Of Malfunction - AL-KO jet 3000-3500 inox classic Betriebsanleitung

en

STORAGE

1. Drain the suction and pressure lines.
2. Unscrew the drain screw and allow the water
to flow out of the pump.
3. Screw the drain screw back in place and store
the pump and accessories in a frost-free en-
vironment.

HELP IN CASE OF MALFUNCTION

CAUTION!
Disconnect the mains plug before any fault rectification work!
Malfunction
Pump drive motor
does not run
Garden pump run-
ning but not deli-
vering.
Delivery rate too
low
14
Possible cause
Impeller blocked
Thermal protection switch has swit-
ched off.
No mains power
Water level too low.
Air in pump housing.
Garden pump drawing air.
Blockage on the suction side.
Pressure line closed off.
Pressure hose kinked
Pressure hose kinked
Hose diameter too small.
Blockage on the suction side
Delivery head too big
ADVICE
If there is a risk of frost, the system must
be completely drained.

DISPOSAL

Do not dispose of worn-out machines
or spent batteries (including recharge-
able batteries) in domestic waste!
The packaging, machine and accessories
are made from recyclable materials and
must be disposed of accordingly.
Rectification
Remove dirt from suction area. Clean
through the opening on the back of the
motor housing with a suitable tool.
Wait until the garden pump is switched
on again by the thermal switch.
Take account of the maximum tempe-
rature of the conveying medium. Have
the garden pump checked out.
Check fuses, have the power supply
checked by a qualified electrician.
Submerge the suction hose deeper.
Filling the garden pump.
Check all connections and the cover
on the filter for leaks.
Important!
Risk of burns from hot water!
Remove dirt from suction area.
Important!
Risk of burns from hot water! Open the
pressure line.
Extend the pressure hose
Extend the pressure hose.
Use a hose with a bigger diameter.
Remove dirt from suction area.
Observe max. delivery head → see
technical data
JET 3000-3500 INOX CLASSIC / JET 3300
Storage