Setup The Display Console - Raddy WF-100C LITE Benutzerhandbuch

1) Wind gust display
2) Wind speed units of measure
3) Wind direction
4) Wind speed average display
5) -
6) Outdoor temperature display
7) Outdoor temperature HI/LO alarm icon
8) Temperature units (°F or °C)
9) Sensor temp change indication
10) Battery low voltage icon
11) Outdoor dew point and feels like icon
12) Outdoor dew point and feels like
temperature display
13) Outdoor humidity display
14) Indoor temperature and
humidity HI/LO alarm icon.
15) Indoor temperature display
16) Indoor humidity display

3.4.2 Setup the Display Console

1) Install the Batteries into the Display Console
Remove the battery lid on the back of the display, install three AAA (alkaline or
lithium) batteries in the battery compartment. The display will beep once and layout
of display will light up for a few seconds.
Replace the battery lid, and unfold out the desk stand and place the console in the
upright position.
17) WIFI network
18) Min/Max reset for 24h icon
19) Week
20) Date
21) Time
22) Time alarm icon
23) Weather forecast
24) Pressure units of measure
25) Pressure (REL and ABS)
display
26) Relative and absolute pressure
27) MOON phase
28) Rainfall units of measure
29) Rainfall display(1h,
24h,WEEK,MONTH, TOTAL)
30) Rainfall relative time
31) Rainfall HI alarm icon
8