Warning And Saftey Note - CS-Electronic Space X1 Turbo Digital Charger Bedienungsanleitung

All manuals and user guides at all-guides.com

2. WARNING AND SAFTEY NOTE

These warnings and safety notes are particularly important. Please follow the
instructions for maximum safety; otherwise the charger and the battery can be dam-
aged or at worst it can cause a fire.
Never leave the charger unsupervised when it is connected to its power supply. If
any malfunction is found, TERMINATE THE PROCESS IMMEDIATELY and refer
to the operation manual.
Keep the charger well away from dust, damp, rain, heat, direct sunshine and
vibration. Never drop it.
The allowable DC input voltage is 11-18V DC.
The allowable AC input voltage is 100-240V AC.
This charger and the battery should be put on a heat-resistant, non-flammable
and non-conductive surface. Never place them on a car seat, carpet or similar
surface. Keep all flammable volatile materials away from the operating area.
Make sure you know the specifications of the battery to be charged or discharged
to ensure it meets the requirements of this charger. If the program is set up incor-
rectly, the battery and charger may be damaged. Fire or explosion can occur due
to overcharging. This warranty is not valid for any damage or subsequent dam-
age arising as a result of a misuse or failure to observe the procedures outlined
in this manual.
To avoid short circuiting between the charge lead, always connect the charge
cable to the charger first, then connect the battery. Reverse the sequence when
disconnecting.
Never attempt to charge or discharge the following types of batteries:
- A battery pack which consists of different types of cells (including different
manufacturers)
- A battery that is already fully charged or just slightly discharged Non-recharge-
able batteries (pose an explosion hazard) A faulty or damaged battery
- A battery fitted with an integral charge circuit or a protection circuit.
- Batteries installed in a device or which are electrically linked to other compo-
nents
- Batteries that are not expressly stated by the manufacturer to be suitable for
the currents the charger delivers during the charge process
Please bear in mind the following points before commencing charging:
- Did you select the appropriate program suitable for the type of battery you are
charging?
- Did you set up adequate current for charging or discharging?
- Have you checked the battery voltage? Lithium battery packs can be wired
in parallel and in series, i.e. a 2-cell pack can be 3.7V (in parallel) or 7.4V (in
series).
- Have you checked that all connections are firm and secure? Make sure there
are no intermittent contacts at any point in the circuit.
3